Stainless steel rolling shutter doors are often used in many factory workshops, because stainless steel rolling shutter doors have many advantages, such as convenient opening, heat preservation, cold insulation, insect prevention, wind prevention, dust prevention, sound insulation, fire prevention, odor prevention, lighting and so on. The stainless steel roller shutter door needs to be convenient for people or vehicles to enter and leave, so it is very necessary to ensure the safety performance of the stainless steel roller shutter door. The bottom edge of the stainless steel roller shutter door is safe and soft. When the safety bottom edge of the stainless steel roller shutter door is installed, its function needs to be tested and accepted. We tell you that you need to pay attention to these steps:
1、 First, close the emergency stop key of the stainless steel rolling shutter door, turn on the power supply of the electric cabinet of the stainless steel rolling shutter door, press the learning key on the bottom receiver panel once, and check that the signal receiver light is on.
2、 Press the pressure hose in the safety bottom cloth pocket of the fast door several times, and the signal indicator flashes to indicate that the reception is successful. Press the bottom pressure hose repeatedly, and the receiver light turns on every time to test that the signal connection is completed.
3、 Open the emergency stop key of the electric control box of the stainless steel roller shutter door, press the pressure hose in the bottom cloth pocket, then the door body of the stainless steel roller shutter door will rise automatically after receiving the signal, and the door body will operate normally.
4、 Jinan electric roller shutter door installation and maintenance personnel believe that in the process of testing the safety bottom edge of the stainless steel roller shutter door and using the fast door, if it is found that the electric control box cannot receive the safety bottom edge signal, it is necessary to check the battery in the safety bottom edge transmitter and the bottom edge pressure hose, and replace the battery if it is found that the battery is exhausted. If the bottom pressure hose is damaged or leaked, it shall be sealed. If necessary, it shall be replaced with a new safety bottom pressure hose.
The above is the relevant content of the question answer. I hope it can help you. If you still have any questions about this problem, you are welcome to follow our website http://www-jnyuqilin-com.connect757.com And consult our staff, will serve you wholeheartedly.